Assessment Checklist

Identify all major fitted modules of the machine.

Identify all points of interest relevant to general operation and maintenance.

Fully isolate the machine (power and air).

Identify all major hazards on the machine.

Differentiate between all light and buzzer modes.

Manually operate the Dust Extractor.

Identify and use all additional safety features of the machine.

Perform the daily maintenance procedures and start up the machine properly.

Open, close and save a job file (including open and print the materials list, load and stack the timbers correctly).

Log in and out of user accounts.

Optimise all members of a job then a subset of a specific material and check the materials list.

Use the cutting and moving speed sliders.

Pause, stop and restart the saw from any point in a job.

Recut a member from both the member list and optimised list.

Run the Optimise On-the-fly Selected function.

Understand the toolbar toggle buttons (Follower, Long Lead, AIT, Waste to Infeed and Job Sequencing) and saw loading options (2* Wide, 2* Thick and Rotate).

Use manual mode and material handling control.

Clean and replace the Print Heads.

Shut down the machine properly.

Modify an existing member using the Complete Member Editing window.

Modify the materials database: add new material, turn material off, change material priority. Show effect on optimisation.

Use the offcuts feature: add new offcut, turn offcut off, disable offcuts feature and change offcut optimisation settings. Show effect on optimisation.

Change the sorting values to reorder members on already optimised job for two different purposes: easy loading and easy sorting.

Change settings to reduce waste on already optimised job (Look Ahead, Priority Emphasis, Materials, Offcuts or Sorting).

Change the Member Designation Label.

Add a new supervisor to the user list and provide a new password.

Replace the Saw Blade.

Remove all necessary guards for full service (Feeder Guards, Dome, Y‑axis End Covers).

Locate all grease points, use the correct type and volume of grease.

Locate the Timing Belts and check their tensions.

Clean and replace the Print Heads.

Clean the Drive Rollers.

Clean and replace the Dust Extractor Bags.

Clean and replace the Photoelectric Sensor Receivers and Emitters on the AIT and Feeders.

Open the Diagnostics window and demonstrate knowledge of fault information.

Diagnose and rectify material feeder slippage error.

Diagnose and rectify Urgent FE error and servo motor Amp Fault.

Diagnose and rectify common AIT loading errors (gap to close, timber not square and wrong material dimension or length).